Soft-db Tenor 24bits Data User Guide Manuel d'utilisateur télécharger pdf (Page 53)

Tenor Data Logger Soft dB inc.

Appendix A: Tenor Driver and Software Installation Procedure

! The Tenor unit is not automatically recognized by

Windows.

Follow each step below precisely to ensure proper

installation of the system.

1) Execute the Tenor24Bit_DataLoggerVer2_0.exe file (see installation disk provided with

the Tenor).

2) Follow the installation procedure. By default, the Tenor software is installed in the

C:\Program Files\Tenor_24Bit directory. Do not launch the software at this point; the

USB driver has to be installed beforehand.

3) Apply power to the Tenor unit (input 12VDC in the rear of the unit). Use the power pack

provided by Soft dB. The Status Board LED of the Tenor unit should turn yellow.

4) Connect the USB cable to the un25it (USB input on the rear of the Tenor unit).

5) Connect the other end of the USB cable to the USB port of your PC.

Windows indicates that a new peripheral has been detected. Follow the procedure

below:

Check No, not this time and then click on Next

User Manual p. 53

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 59

Pas de commentaire

Soft-db Tenor 24bits Data User Guide Manuel d'utilisateur Page 53